Tips for Replacing Broken Garage Door Springs

When you are facing the problem of broken garage door springs that need to be replaced you can either call a professional garage door experts such as, garage door spring repair service in Atlanta, Georgia or you can handle it on your own. These springs are long, heavy, and complex devices which are used to lift and lower the garage door. Therefore if you are experiencing the problem of broken garage door springs that need to be taken care of then there are few important steps that you should keep in mind to get the job done. Following mentioned points will help you to ensure that garage door project can be done easily.

The most important point that you need to be keep in mind is to make sure that you have disconnected the power supply so that you do not get electrocuted while performing the garage door works. Disconnect the power cord of the opener from the garage door. This facility is available for the newer models of garage doors while with the older models you may need to turn off the circuit breaker or remove the fuse to disconnect the power supply. Look closely at the broken spring to buy the right type of spring and to ensure that both springs are same in type and dimensions. While picking the spring, avoid rubbing them. Don’t touch the winding cones of the new springs.

You also need to marker or any other writing instrument to mark the torsion shaft ends. It is important because it helps you to make sure that you will have properly aligned garage door when you have finished the job of garage door spring replacement. You should unwind the unbroken spring off and unfasten the screws and blots that securing the cones and mounting brackets together and then remove the screws.

Once you have finished this process, it is a time to replace old spring along with its hardware. After doing the step, it is time to wind up the new springs. After performing these steps successfully, you need to make sure that the balance of your garage door is aligned correctly. In order to reduce the hurdles and frictions, you should apply any good lubricant.

Once you have confirmed that your garage door is balanced correctly and all the parts are tightened securely, it is a time to reconnect the garage door opener. It is a rule that you should not play with the garage door but here you need to open or close the garage door multiple times to make sure that it is working correctly. Replacing garage door springs is not an easy task if you are not conscious. It can be dangerous job that can give you serious injuries if you handled properly. You could lose your limbs, hands, legs, or even a life. So it is highly advised that hire professional garage door technician to handle the project.